EDGE Gas Lens Series welding cups for 9, 20, 25 torches, are hand-made in the USA. Each cup is made out of laboratory-grade borosilicate glass, most commonly known as Pyrex.

EDGE Welding Cups are made to exacting standards and put through our quality-control system to ensure that every cup is made to fit right. Each cup is size labeled to ensure that the welder isn’t wasting time trying to find the correct size cup. Every cup is oven annealed to ensure that the life of the cup is maximized.

 Guidelines to get started…

EDGE ADAPTER AND EDGE CUP MUST BE FULLY SEATED ONTO THE TEFLON HEAT SHIELD FOR SAFETY PROPER GAS FLOW.

GL, CB920. CB1718 (P4-10)

*Can be used with any size and type electrode.

*Best used with metals such as Stainless steel, Titanium and Inconel.

*Aluminum based material should use with #10 or #12 in shorter runs

*We do not recommend walking the cup with Pyrex glass cup. (This will cause premature failure)

GL-P12, GL-P15 AND GL-18

**Best used with metals such as: Stainless steel, Titanium, Inconel,Nickel based & thin aluminum based.

*Can be used with 1/16, 3/32, 1/8 and 5/32 electrode

*The tungsten can be extended up to 3” out in controlled environment for clearance.

*We do not recommend walking the Pyrex glass cup. (This will cause premature failure.)

GL920 QUARTZ CUPS

*Can be used with any metals

*Can be used with any size tungsten unless using diffuser technology.

*All sizes of cups can be used with EDGE diffuser technology.